Unit Configuration
Unit [n] > Unit Configuration
Use to display and confirm hardware and software configurations and calibrations of the analyzer.
| Fields | Description |
|---|---|
| Configuration [group box] |
Displays the IP address used by the analysis program, serial number, and type of analyzer. IP address. Displays the IP address of the analyzer. Change IP. Displays the Board ID dialog, which describes the circuit boards in the analyzer. Use the Board drop-down list to select a board to view. Board ID. Click to display information from the circuit boards in the analyzer. Use the drop-down list to select a board to view. The parameters shown cannot be edited. Serial #. Displays the analyzer serial number. |
|
CryoCooler [group box] |
Select the CryoCooler type attached to the AutoChem. If no CryoCooler is attached to the instrument, this selection does nothing. CryoCooler II - For use with all AutoChem instruments. CryoCooler III - For use on the AutoChem III only. |
| Loop volume [text box] | Enter the volume of the gas injection loop. Three standard volume loops are provided with the analyzer. The loop volume is determined by performing a loop calibration. See Loop Calibration for TCD Analyzers Tutorial. |
| Mass Flow Controller Range [group box] | Displays the range of each mass flow controller. |
| Options [group box] |
Displays options installed on the analyzer. |
| Software Versions [group box] | Displays the software versions of the MIC BIOS, controller software, and analysis program. |
Copyright © 2022 - 2024. Micromeritics Instrument Corporation. All rights reserved.
|
|
|
|
|